This Standard defines a set of operational instructions that
will meet the requirements of remote agents wishing to control the
energy consumption of pump-units, and establishes a consistent
approach to the method of connecting the demand response interface
to the demand response enabling device (DRED).
Pump-unit controllers covered by this Standard include (but are
not restricted to) the following:
(a) Controllers integral with pump-units within the scope of the
AS 5102 series.
(b) Time clocks intended for installation between the mains
electricity supply and the pool equipment.
(c) Sanitization controllers intended to regulate the operation
of the pump-unit as well as the sanitizer.
(d) Heater controllers intended to regulate the operation of the
pump-unit as well as the heater.
A pump-unit controller is not covered by this Standard if one or
more of the following applies:
(i) It uses three-phase power.
(ii) It uses single phase power but is intended for hard-wired
installation (according to the manufacturer's instructions) and is
supplied without a plug.
(iii) It incorporates a chlorinator with an output of 50 g/h or
greater.