This part of ISO 15186 specifies a sound intensity method to determine the sound reduction index and the elementnormalized level difference of building elements at low frequencies. This method has significantly better reproducibility in a typical test facility than those of ISO 140-3, ISO 140-10 and ISO 15186-1. The results are more independent of the room dimensions of the laboratory and closer to values that would be measured between rooms of volume greater than . This part of ISO 15186 is applicable in the frequency range to but is mainly intended for the frequency range to . NOTE For elements faced with thick, porous absorbers, the recommended frequency range is to . The main differences between the methods of ISO 15186-1 and ISO 15186-3 are that in ISO 15186-3 a) the sound pressure level of the source room is measured close to the surface of the test specimen, and b) the surface opposite the test specimen in the receiving room is highly absorbing and converts the room acoustically into a duct with several propagating cross-modes above the lowest cut-on frequency. The results found by the method of ISO 15186-3 can be combined with those of ISO 140-3 and ISO 15186-1 to produce data in the frequency range to 1.2

Customers who purchased DS DS/EN ISO 15186-3
also purchased

• ESD S20.20 : For the Development of an Electrostatic Discharge Control Program for – Protection of Electrical and Electronic Parts, Assemblies and Equipment (Excluding Electrically Initiated Explosive Devices)-Includes Interpretation Bulletin: 06/19/08
• API 510 : Pressure Vessel Inspection Code: In-Service Inspection, Rating, Repair, and Alteration-Ninth Edition
• API 570 : Piping Inspection Code: In-service Inspection, Rating, Repair, and Alteration of Piping Systems-Third Edition
• API 579-1 CD : Fitness-for-Service-Second Edition

See More Documents