Procedures included within this specification are intended to cover performance testing at all phases of development, production, and field analysis of any USB cable assemblies and associated connections that constitute the electrical connection systems between the consumer peripheral interface and the USB computer source in road vehicle applications. These procedures are only applicable to the USB connector and the cable. Unless otherwise specified, all of the tests listed in this specification are for both consumer and nonconsumer interface connectors.

IMPORTANT NOTICE: All suppliers developing an automotive grade USB system must use components that have been validated and approved by an authorized USB testing facility per USB 2.0. In any intended vehicle application, if the products covered by this specification are, or may be, subjected to conditions beyond those described in this document, they must pass special tests simulating the actual conditions to be encountered before they can be considered acceptable for actual vehicle application. Products certified by their supplier as having passed specific applicable portions of this specification are not to be used in applications where conditions may exceed those for which the product has been satisfactorily tested.

The high frequency test methods are written for test professionals who are knowledgeable in the electronics field and are trained to use the referenced equipment. Because the measurement values are heavily influenced by the fixturing and equipment this method cannot describe all of the possible combinations. The major equipment manufacturers provide Application Notes for more in-depth technical description of how to optimize the use of their equipment.

The Authorized Person is the final authority as to what tests are to be performed on his or her parts and for what purpose these tests are required. He or she is also the final authority for resolving any questions related to testing to this specification and to authorizing any deviations to the equipment or procedures contained in this specification. Any such deviation must be documented and included in the final test report.

Guidance as to the recommended tests for selected purposes is given in the charts in Appendix C. In the absence of contrary direction from the Authorized Person in the test request/order, all electrical connectors and their associated terminals and other components are required to meet all applicable portions of this document with the following exception:

Specific tests that are not required or additional test requirements as specified in any document in the hierarchy of Section 3.1.

All suppliers of USB automotive assemblies must use certified USB 2.0 components (ie. USB mini-B receptacle, standard A stainless steel receptacle or equivalent ruggedized receptacle, mini B plug). For non-consumer interfaces, please refer to the USCAR footprint drawing labeled 999-U-USB-Z01.pdf. The drawing can be found at www.ewcap.uscarteams.org

Refer to USB 2.0 website (www.usb.org) for approved supplier list

Customers who purchased SAE USCAR-30
also purchased

• SAE USCAR-2 : Performance Specification for Automotive Electrical Connector Systems-Revision 5
• GMW GMW14333 : Resistance to Fuels of Exteriors Automotive Materials and Components-English; Revision B; Replaces GMI 60265
• GMW GMW25 : Mechanical Properties and Material Requirements for Externally Threaded Fasteners-English; Revision A
• GMW GMW3235 : Fogging Characteristics of Trim Materials-Issue 2; English

See More Documents