Purpose

This part of SAE J2337 specifies dimensions, design, and performance requirements for eight connectors using a conical seal to insure leak proof performance with a design factor of 4 to 1.

Field of Application

These connectors are intended for general and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures. These connectors are capable of providing leak proof full flow connections in hydraulic systems operating from 95 kPa vacuum to the working pressures shown in Table 1. Since many factors influence the pressure at which hydraulic systems do or do not perform satisfactorily, these values should not be construed as guaranteed minimums. For any application, it is recommended that sufficient testing be conducted and reviewed by both the user and manufacturer to ensure that the required performance levels are met.

CAUTION: For use of these connectors in conditions outside the pressure and temperature limits specified, contact the manufacturer.

Customers who purchased SAE J2337-2
also purchased

• AGMA 6011-I03 : Specification for High Speed Helical Gear Units
• AWS A2.4 : Standard Symbols for Welding, Brazing, and Nondestructive Examination-7th Edition
• SAE AS568C : Aerospace Size Standard for O-rings

See More Documents