This test method specifies the operating procedures for a controlled irradiance, water cooled xenon-arc apparatus used for the accelerated exposure of various automotive interior trim components.

Test durations, as well as any exceptions to the sample preparation and performance evaluation procedures contained in this document, are covered in material specifications of the different automotive manufacturers.

This standard is limited to the models of xenon arc test apparatus specified in the Section on Equipment.

All other models of xenon arc test apparatus must use SAE J2412 to perform the test conditions specified in SAE J1885. SAE J2412 is the performance standard based on the test parameters of SAE J1885. Use of xenon arc test apparatus to perform SAE J2412 must be agreed upon by contractual parties.

Rationale

The SAE Committee on Textiles and Flexible Plastics Specifications is cancelling SAE J1885 due the fact it is equipment specific, and will be superseded by SAE J2412, on or about January 2008, per the policy outlined in TSB (Technical Standards Board) of SAE.

Customers who purchased SAE J1885
also purchased

• SAE J2527 : Performance Based Standard for Accelerated Exposure of Automotive Exterior Materials Using A Controlled Irradiance Xenon-Arc Apparatus
• SAE J1756 : (R) Determination of the Fogging Characteristics of Interior Automotive Materials
• SAE J2412 : Accelerated Exposure of Automotive Interior Trim Components Using a Controlled Irradiance Xenon-Arc Apparatus
• SAE J1960 : Accelerated Exposure of Automotive Exterior Materials Using a Controlled Irradiance Water-cooled Xenon Arc Apparatus

See More Documents