This SAE Recommended Practice covers the mechanical and quality requirements for steel tapping screws used in automotive and related industries. It does not apply to corrosion resistant (stainless) steel screws. (Dimensional requirements for most types of screws mentioned herein are covered in ASME B 18.6.4, 'Thread Forming and Thread Cutting Tapping Screws and Metallic Drive Screws'.)

The primary objective of the specification is to insure that screws form or cut mating threads in materials of construction into which they are normally driven, without deforming their own thread and without breaking during assembly or service.

NOTE - Certain limitations on basic material and manufacturing processes have been incorporated because the size and configuration of the parts under consideration make them vulnerable to relatively small variations in chemistry, heat treatment, etc., and because experience has shown that in processing it is difficult to keep these variables consistently "in balance." Until improved performance tests are developed, these limitations will supplement the "performance" features of the specification.

Rationale

The standard SAE J478 has been cancelled and ASME B 18.6.4 is the consensus replacement of that standard.

Customers who purchased SAE J933
also purchased

• ASTM E384 : Standard Test Method for Knoop and Vickers Hardness of Materials
• ASTM A568/A568M REV B : Standard Specification for Steel, Sheet, Carbon, Structural, and High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for
• ASTM E1918 : Standard Test Method for Measuring Solar Reflectance of Horizontal and Low-Sloped Surfaces in the Field
• ASTM F606 REV A : Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets

See More Documents