This SAE Recommended Practice contains dimensions and their tolerances concerning disc wheel to hub or drum interface areas for commercial vehicles and multipurpose passenger vehicles. Stamped disc wheels for single applications and special or less common applications are not covered in this document.

Purpose

This document defines wheel mounting systems and documents the dimensions and tolerances necessary to maintain serviceability, and interchangeability in the interface areas. To be consistent with ISO, it is divided into two sections (I and II). Section I is in concert with ISO 4107, describing mounting systems currently used internationally and nominated for, or included in, the international standard for bolt circle interfaces. Section II records information on current mounting systems also used in North America. Components of different mounting systems with common bolt patterns could be mis-assembled together and cause service problems. Therefore, it is important to note that each mounting system should be treated individually and their components not be intermixed.

Customers who purchased SAE J694
also purchased

• SAE J267 : Wheels/Rims—Performance Requirements and Test Procedures—Truck and Bus
• AATCC 124 : Smoothness Appearance of Fabrics after Repeated Home Laundering
• AATCC 130 : Soil Release: Oily Stain Release Method
• AATCC 132 : Colorfastness to Drycleaning

See More Documents